|You can squeeze them in quite nicely.|
|Cut out all the diamonds, No extra bits needed with this design.|
|start by working on sets of 4 pieces.|
|Fold THREE of the pieces down the centre line with a valley fold.|
The fourth piece is left flat.
|Apply glue to one half of one diamond.|
I have used PVA glue to give me plenty of time to get a good alignment.
|Use this to attach the next folded piece.|
Then add the third folded piece in the same way.
|One all three folded pieces are glued together, glue the flat piece across the back|
|Take time get this set of four lined up as carefully as possible.|
|Repeat until you have 5 sets of 4 . You should have 5 bit left over.|
|Now use a spare piece of paper as a base to glue these all together.|
I have used a 2inch circle punch but it will be hidden so that is not essential
and I probably wouldn't have bothered it I wasn't taking photos for you guys.
|Glue your first set with the broadest point as close to the centre of the circle as you can.|
Gradually add all 5 sets you have made to create a circle.
I have used the final 5 diamonds to cleverly cover the back
and somehow can't find the photos of that bit so part two will be tomorrow